Just a few of the benefits of having your parts cut on a waterjet:

• Cheaper than other processes.
• Fast turnaround.
• No heat is generated, so there are no heat affected zones.  This is cold cutting!
• No mechanical stresses.
• Cuts virtually any shape.
• Leaves a satin smooth finish.  No secondary finishing is usually required.
• Cuts virtually any material:
  • Pre hardened steel
  • Mild steel
  • Exotics like Titanium, Inconel, Hastalloy
  • Gummy 304 stainless (most steels cut at the same speed, whether hardened, or not.)
  • Copper, Brass, Aluminum: They are a cinch!
  • Brittle materials like glass, ceramic, quartz, stone.
  • Laminates
  • Flammable materials
• Cuts thin stuff, or thick stuff.
• Makes all sorts of shapes with only one tool.
• Cuts wide range of thickness’ to reasonable tolerance up to 2" thick, up to 5" thick where tolerance is less important, or in soft materials.
• Clean cutting process without gasses or oils.
• Narrow kerf removes only a small amount of material.
• Your "scrap" metal is easier to recycle or re-use (no oily chips!)
• You can trade off tolerance vs speed from feature to feature on your part.
• Can easily switch between high production, and single piece production, on the same machine.

• You draw the part, we cut the part.... It is THAT easy!

All text, images, etc. copyright 2002 by D.C. Waterjet, ALL RIGHTS RESERVED, #