Why Us?
Just a few of the benefits of having your parts cut on a waterjet:
- Cheaper than other processes.
- Fast turnaround.
- No heat is generated, so there are no heat affected zones. This is cold cutting!
- No mechanical stresses.
- Cuts virtually any shape.
- Leaves a satin smooth finish. No secondary finishing is usually required.
- Cuts virtually any material:
- Pre hardened steel
- Mild steel
- Exotics like Titanium, Inconel, Hastalloy
- Gummy 304 stainless (most steels cut at the same speed, whether hardened, or not.)
- Copper, Brass, Aluminum: They are a cinch!
- Brittle materials like glass, ceramic, quartz, stone.
- Laminates
- Flammable materials
- Cuts thin stuff, or thick stuff.
- Makes all sorts of shapes with only one tool.
- Cuts wide range of thickness' to reasonable tolerance up to 2" thick, up to 5" thick where tolerance is less important, or in soft materials.
- Clean cutting process without gasses or oils.
- Narrow kerf removes only a small amount of material.
- Your "scrap" metal is easier to recycle or re-use (no oily chips!)
- You can trade off tolerance vs speed from feature to feature on your part.
- Can easily switch between high production, and single piece production, on the same machine.
- You draw the part, we cut the part.... It is THAT easy!
All text, images, etc. Copyright 2006 by D.C. Waterjet, ALL RIGHTS RESERVED
